Tubular plate assembly for sightseeing car battery
The electric sightseeing car battery is assembled with a tubular plate, which has the advantage that the electromotive force is relatively stable during discharge and is highly corrosive to the environment. The lead-acid battery has a stable working voltage, a wide range of current using a thermometer, can be charged and discharged for hundreds of cycles, and has good storage performance. Fault tolerance of single-chip microcomputer failure: The single-chip microcomputer is used to generate signals to control the magnitude of the discharge current. When the single-chip microcomputer program generates a "runaway", it can be automatically reset by the gatekeeper.
The system can not only carry out the charge and discharge test according to the characteristics of different batteries and according to the pre-programmed plan, but also adjust the experimental plan at any time according to the specific state of the battery during the experiment. The positive pole of the charger is connected to the positive pole of the battery, and the negative pole of the charger is connected to the negative pole of the battery. Confirm that the battery terminal posts are clean and the charging circuit is well connected. It is recommended to use a constant voltage 160 volt current limiting 25 amp charger to charge the battery.
When the battery is in floating charging operation, the battery cell voltage should not be lower than 220V. If the cell voltage is lower than 220V, equalization charging is required. The method of balanced charging is: the charging voltage is 235V/piece, and the charging time is 12 hours. The power supply device must have a more stable operating environment to avoid damage. The use of electric sightseeing vehicles must ensure a better way to avoid bumps in daily applications. Only in this way can the safety of the main components and structures of the equipment be improved. Spend.
常熟市喬佳機械設(shè)備制造有限公司
